Basic Description
This is a remix of a CR-Touch mount. https://www.printables.com/model/255096-sprite-extruder-ender-s1-pluspro-cr-touch-mount-fo
I redesigned it for my Ender 3 S1 Pro.
Reasons for remix
The original had its X-offset being-55.5mm however this didn't allow me enough room for my X-axis to reach for screw tilt leveling located on the front right-hand side. Hence I've made changes that reduced the X-offset to -49.3mm. I've added a gap to allow for the connecting cable to be managed through and held in place.
Print Settings
Layer height: 0.2mm
Base layer height: 0.3mm
Infill: 20%
Material: PETG
Walls: 3
Printer: Ender 3 S1 Pro
Supports: Everywhere.
